Notes on installation and use of cable gland (2)

Publish Time: Author: Site Editor

3.When the copper tube is pressed the pressure can not be too hard, some points may be raised after pressing the copper tube. Thus need to use a file to rub flat when necessary, and do not leave any burs.

4.The scale of the cable joint must be operated in strict accordance with the instructions in the drawing, and it is also required to be careful when pulling out the support in the reserved pipe. Do not be careless, otherwise you will be injured.

      The above is about the nylon cable gland in the installation and use of some matters need to pay attention to before installation and use, so that the cable gland can be successfully installed and used.

12v dc motor Gearbox Manufacturers small gear motor micro brushless motor